Specialist roof waterproofing in Murree for hillside homes, hotels, guest houses, cottages and shops. Wellcool seals sloped sheet roofs, flat slabs and terraces against heavy monsoon rain, snow, freeze–thaw and constant mountain damp.
★★★★★ Trusted by homeowners & businesses across Pakistan
Systems that survive freeze–thaw
Sheets, ridges, valleys and flashings
Written quote before work
Murree is Pakistan’s best-known hill station, set at around 2,000 metres in the forested hills north-east of Islamabad. Its climate is completely different from the plains below. Summers are mild and pleasant, which draws large numbers of visitors, but the area receives heavy rainfall, especially during the monsoon from July to September, when cloud, mist and long rain spells can continue for days. Winters are cold, with regular snowfall from December to February, frost on most nights and frequent freeze–thaw cycles as snow melts in the day and refreezes at night. Fog, low cloud and high humidity keep buildings damp for much of the year, and moss and algae grow quickly on shaded surfaces.
Murree’s buildings are equally distinct. Many homes and cottages have steep, sloped roofs of corrugated galvanised iron (CGI) or other sheets, often painted green or red, while newer houses, hotels and plazas may have flat RCC roofs and terraces. Buildings are frequently built on steep slopes, with retaining walls and back walls set against the hillside. Wellcool provides roof waterproofing in Murree for all of these — sheet roofs, flat slabs, terraces, gutters and hillside walls — using flexible, cold-resistant systems and careful detailing for snow, melt water and constant moisture. Every job begins with an inspection and a clear written quote.
In the plains, the main enemies of a roof are heat and occasional storms. In Murree, the enemies are water and cold, almost all year round. Monsoon rain is heavy and persistent; buildings may be wet for days with little chance to dry under cloud and mist. In winter, snow sits on roofs and in gutters, adds weight and slowly melts, feeding water into every gap. At night, that melt water refreezes. Water that has crept into a crack or a sheet overlap expands as it freezes, prising the gap wider. Repeat this through a whole winter and small cracks become big ones, sheet fixings loosen and sealants fail.
The constant damp also encourages moss, lichen and algae, which hold moisture against surfaces and break down weak coatings. Wood used in eaves, fascia and older structures can rot if it stays wet. And because many buildings are cut into slopes, water flowing down the hillside after rain and snowmelt can soak back walls and foundations. A good waterproofing system in Murree therefore has to stay flexible in sub-zero temperatures, tolerate long periods of moisture, resist biological growth and be detailed so snow and melt water are shed quickly.
Corrugated iron and similar sheet roofs are common across Murree because they shed snow and rain quickly and are relatively light on hillside structures. But they have their own weak points. Over the years, the galvanised or painted surface wears, rust starts at cut edges, overlaps and nail or screw holes. Fixings loosen as sheets expand and contract with temperature changes and as snow loads press on them. Ridge caps, valleys between roof slopes and flashings around chimneys, dormer windows and walls are the most common leak points, and wind-driven rain can be pushed up under poorly lapped sheets.
For sheet roofs, we start by inspecting every overlap, fixing, ridge, valley and flashing. Loose or rusted fixings are replaced or sealed with weatherproof washers, open laps are sealed with flexible sealant and tape, and rust spots are cleaned and treated. Valleys and flashings are rebuilt or sealed where they have failed. The whole roof can then be coated with a flexible, rust-inhibiting waterproof coating that adds a seamless layer of protection and refreshes the roof’s appearance. Where sheets are badly corroded, we will tell you honestly that replacement is better value than coating.
Newer homes, hotels and commercial buildings in Murree increasingly have flat concrete roofs and terraces, often designed to enjoy the views. Flat roofs at altitude face a tougher test than in the plains: snow can sit on them for days, melt water ponds if drainage is slow, and freeze–thaw attacks every crack. Outlets can freeze or be blocked by snow and ice, causing water to back up against parapets and door thresholds.
For these roofs, we use elastomeric or polyurethane liquid membranes that remain flexible in the cold, reinforced at all corners, upstands and outlets. Slopes are checked and corrected so water moves quickly to outlets, and outlets are sized and positioned to reduce the risk of freezing blockages. Terrace door thresholds are raised or detailed so melt water cannot enter rooms. Where terraces are tiled, waterproofing is placed beneath the tiles with a proper slope and protected edges.
In Murree inspections we commonly find:
We work on family homes and holiday cottages, hotels and guest houses, apartments and newer residential buildings, shops and commercial buildings in busy market areas, schools and institutional buildings, and properties in surrounding villages and hill settlements. For hotels and guest houses, a leak during the tourist season directly affects guests and reviews, so we plan work for quieter periods and can phase it room by room or section by section.
A rust-inhibiting, elastomeric coating applied after sealing fixings and laps. It forms a continuous, flexible skin over sheets that remains effective in cold and wet weather.
Polyurethane or high-performance elastomeric membranes that stay elastic at low temperatures and resist freeze–thaw damage, reinforced with fabric at critical details.
For back walls and basements set against the slope, cementitious or crystalline waterproofing treatments help resist water pressure from the ground. See basement waterproofing and dampness and seepage solutions.
Where gutters, valleys and flashings have failed, we repair or replace them and seal joints so snowmelt and rain are carried away from walls.
Systems chosen for rain, snow and freeze–thaw.
From CGI cottages to RCC hotels and terraces.
Work planned for dry, workable weather.
Photos and written scope, even for remote owners.
Sheets, slabs, gutters, flashings and back walls checked.
System, repairs and schedule set out clearly.
Moss, algae, rust and loose material removed.
Fixings, laps, valleys, cracks and outlets fixed.
Primer and flexible coats in suitable weather.
Drainage checked and care advice shared.
Timing is crucial in the hills. The best window for roof work in Murree is usually from late April to June, after the last snow and before the monsoon, when days are mild and drier. September to October, after the monsoon and before winter, is another good window. Winter work on exposed roofs is generally impractical because of snow, frost and low temperatures that prevent proper curing. During the monsoon, frequent rain and mist make full systems difficult, though we can carry out emergency repairs between showers. Because the workable season is short, it is wise to book inspections early.
We inspect before quoting, since roofs in the hills vary greatly. Cost depends on:
Clear gutters and valleys of pine needles, leaves and debris before the monsoon and again before winter. After heavy snowfall, avoid letting snow build up excessively on flat roofs and around outlets, and never chip ice off coatings with sharp tools. Check sheet roofs each spring for loose fixings, rust spots and lifted laps. Remove moss and algae from shaded areas gently. Make sure downpipes discharge away from foundations and that water running down the slope is diverted around the building. Arrange an inspection every spring to catch winter damage before the monsoon.
For Murree’s hospitality businesses, a leaking ceiling during the busy summer or winter snow season means unhappy guests and lost bookings. We recommend inspecting hotel roofs in spring and carrying out work before peak periods. Large roofs can be treated in sections so rooms stay in use. We also check terraces, balconies, water tanks and washrooms, which are frequent sources of damp in hotel rooms. See commercial building and commercial waterproofing services for larger properties.
Get your Murree roof ready before the monsoon or winter snow. Call or WhatsApp 0321-4156036 or send photos on WhatsApp for a free inspection and written quote.
We also offer terrace and balcony waterproofing, washroom waterproofing, tank waterproofing, wall and ceiling waterproofing, protective coatings, exterior wall protection and exterior painting in Murree.
We also cover Islamabad, Rawalpindi, Kahuta, Kotli Sattian and Abbottabad. See the full list on our locations page.
Not all water inside Murree homes comes from outside. In winter, rooms are heated with gas heaters, stoves or electric heaters while the roof above is freezing cold. Warm, moist indoor air meets the cold underside of a sheet roof or an uninsulated slab and condenses, dripping back down or soaking into ceilings. Owners often mistake this for a leak. The tell-tale signs are drips on very cold, dry days with no rain or snowmelt, damp spread evenly across a ceiling rather than in one spot, and black mould in corners and behind furniture.
The solution is a combination of good ventilation and insulation. Adding an insulating layer under sheets or above a slab keeps the inner surface warmer so moisture does not condense, and it also reduces heating costs. Our roof insulation options can be combined with waterproofing in one job. During inspection we will help you tell the difference between a true leak and condensation, so you invest in the right fix.
Many Murree buildings are stepped into the hillside, so the roof of a lower storey may also act as a terrace or path for the building above, and back walls hold up earth. Rain and snowmelt run down the slope and collect behind walls and on lower roofs. We look at how water moves across the whole site, then combine roof waterproofing with drainage channels, sealed terrace levels and wall treatments so water is directed safely around and away from the building rather than through it.
Every Wellcool customer receives the same complete service — from the first inspection to the final check. No shortcuts, no half-finished work.
Sheets, slabs, gutters and walls inspected.
Loose screws, nails and overlaps sealed.
Corroded areas cleaned and primed.
Snowmelt and rain routed away from walls.
Systems that stay elastic below freezing.
Biological growth cleared before coating.
Your building is our priority. From the first phone call to the final check, our team treats your property as if it were our own. We arrive on time, protect your home while we work, and leave the site clean.
We follow one simple rule: prepare properly, apply correctly, check thoroughly. That is how results last for years — not just for one season.
Punjab, KPK & Islamabad
Site survey & quote
Tested systems
Clear timelines
Yes. We inspect overlaps, fixings, ridges, valleys and flashings, seal or replace failed parts, treat rust and then apply a flexible waterproof coating. If sheets are badly corroded or thin, we will advise whether replacement is better value than coating.
Yes, if the right system is used. We choose cold-flexible membranes and coatings that remain elastic below freezing and resist freeze–thaw damage. Correct slope and drainage are also important so melt water does not pond and refreeze on the roof.
Late April to June and September to October are best. Winter snow and frost and monsoon rain make full systems difficult. Because the good weather window is short, we recommend booking an inspection early in spring.
Often not. Rooms built against the hillside can take in moisture from the ground and water flowing down the slope. This needs wall or basement waterproofing and proper drainage around the building, not just roof work. We assess both during inspection.
Yes. We plan work in sections and schedule it for quieter periods where possible, so most rooms remain in use. We coordinate with management on access, noise and safety, and keep work areas tidy.
Snow and ice put heavy loads on gutters, and freezing water inside them can split joints. Pine needles and leaves cause blockages that make water overflow onto walls. Stronger fixings, sealed joints, leaf guards and regular cleaning help them last much longer.
Yes. We serve properties in surrounding hill settlements and villages, subject to access. Send your location and photos on WhatsApp to 0321-4156036 and we will advise on scheduling.
Protect your Murree home, cottage or hotel against rain, snow and damp.
Stop washroom damp in homes and hotels.
Insulation options that also help in winter.
Durable coatings for sheet and slab roofs.
Leak-proof tanks in hill homes.
Fix damp walls and ceilings.
Stop seepage from slopes and roofs.
Targeted repair of roof leaks.
Paint that withstands hill weather.
Tell us your city and the problem, send a few photos on WhatsApp, and our team will arrange a site visit. No obligation, no hidden cost.
Call, WhatsApp or fill in our quote form for a free estimate.